Top > JDR > Numerical Model for Bank Erosion in the Brahmaputra River

single-dr.php

JDR Vol.11 No.6 pp. 1073-1081
(2016)
doi: 10.20965/jdr.2016.p1073

Paper:

Views over last 60 days: 916

Numerical Model for Bank Erosion in the Brahmaputra River

Robin K. Biswas*,**,†, Atsuhiro Yorozuya**, and Shinji Egashira**

*Disaster Management Program (DMP), National Graduate Institute for Policy Studies (GRIPS)
7-22-1 Roppongi, Minato-ku, Tokyo 106-8677, Japan

†Corresponding author,

**International Centre for Water Hazard and Risk Management (ICHARM),
Public Works Research Institute (PWRI), Ibaraki, Japan

Received:
July 4, 2016
Accepted:
October 3, 2016
Published:
December 1, 2016
Creative Commons License
Keywords:
2D depth integrated model, bank erosion, stretchable grids, suspended sediment, brahmaputra river
Abstract
A method is proposed to predict bank erosion and sand bar migration in river reaches where suspended sediment transport is dominant. The method focuses on the influence of the lateral bed slope on the erosion and deposition rate of suspended sediment, as well as on the profile of lateral bedload transport, assuming that geometric similarity holds in the bank region. In the proposed model, the erosion and deposition rate can be evaluated using either the bed shear stress at a reference location or the average bed shear stress in the bank region. In order to simulate bank erosion and associated bank shifting with a depth-integrated-base treatment, stretchable grids were added to the conventional coarse grid system near the bank. The proposed method, including the bank erosion model, is applied to the lower reach of the Brahmaputra River, which is ∼90 km long and ∼12.50 km wide. The computed results on bank shifting, sand bar migration, and sediment transport rates are compared with data obtained from field investigations and remote sensing. These results suggest that the proposed method is applicable for predicting sediment issues in river reaches dominated by suspended sediment.
Cite this article as:
R. Biswas, A. Yorozuya, and S. Egashira, “Numerical Model for Bank Erosion in the Brahmaputra River,” J. Disaster Res., Vol.11 No.6, pp. 1073-1081, 2016.
Data files:
References
  1. [1] K. Hasegawa, “Bank erosion discharge based on a non-equilibrium theory,” Proc. JSCE, Tokyo, Vol.316, pp. 37-50 (in Japanese), December 1981.
  2. [2] ASCE Task Committee on Hydraulics, Bank Mechanics, and Modelling of River Width Adjustment, “River Width Adjustment. I: Process and Mechanisms,” J. of Hydraulic Engineering, Vol.124, No.9, pp. 881-902, September 1998.
  3. [3] ASCE Task Committee on Hydraulics, Bank Mechanics, and Modelling of River Width Adjustment, “River Width Adjustment. II: Modelling,” J. of Hydraulic Engineering, Vol.124, No.9, pp. 903-917, September 1998.
  4. [4] H. Nakagawa, and T. Tsujimoto, “Sand bed instability due to bed load motion,” J. of Hydraulic Division, ASCE, Vol.106, No.12, pp. 2029-2051, 1980.
  5. [5] N. Nagata, T. Hosoda, and Y. Muramoto, “Numerical analysis of river channel processes with bank erosion,” J. of Hydraulic Engineering, Vol.126, No.4, pp. 243-252, April 2000.
  6. [6] C.Jang, and Y. Shimizu, “Numerical simulation of relatively wide, shallow channels with erodible banks,” J. of Hydraulic Engineering, Vol.131, No.7, pp. 565-575, July 2005.
  7. [7] J. G. Duan and P. Y. Julien “Numerical simulation of meander evolution,” J. of Hydrology, Vol.391, pp. 34-46, July 2010.
  8. [8] S. E. Darby, A. M. Alabyan, and M. J. Van de Wiel, “Numerical simulation of bank erosion and channel migration in meandering rivers,” Water Resources Research, Vol.38, No.9, 1163, pp. 2-1-2-12, September 2002.
  9. [9] J. D. Anderson, Computational Fluid Dynamics: The Basic with Application, McGraw-Hill, Inc., NY, USA, 1995.
  10. [10] R. K. Biswas, S. Egashira and A. Yorozuya, “Influence of lateral bed slope on erosion deposition process in suspended-sediment dominated river,” J. of Japan Society of Civil Engineers, Ser. B1 (Hydraulic Engineering), Vol.71, No.4, pp. 871-876, 2015.
  11. [11] H. Takebayashi, S. Egashira, and T. Okabe, “Braided streams formed on bed beds with non-uniform sediment,” Proc. 3rd IAHR Symposium on River, Coastal and Estuarine Morphodynamics, pp. 787-798, 2003.
  12. [12] K. Ashida, and M. Michiue, “Study on hydraulic resistance and bedload transport rate in alluvial streams,” Transactions of JSCE, Vol.206, pp. 59-69, 1972.
  13. [13] K. Ashida, S. Egashira, and B. Y. Liu, “Numerical method on sediment sorting and bed variation in meander channel,” Annual J. of. Hydr. Engg., JSCE, Vol.35, pp. 383-390, 1991.
  14. [14] Y. Shimizu and T. Itakura, “Calculation of flow andbed deformation with a general non-orthogonal coordinate system,” Proc. of XXIV IAHR Congress, Madrid, Spain, C-2, pp. 41-48, 1991.
  15. [15] W. W. Rubey, “Settling velocities of gravel, sand and silt particles,” American J. of Science, Vol.25, pp. 325-338, 1933.
  16. [16] E. W. Lane, and A. A. Kalinske, “Engineering calculation of suspended sediment,” Trans. A.G.U., Vol.22, 1941.
  17. [17] H. Takebayashi and S. Egashira, “Formative process and domain of a self-formed cannel,” Proc. of JSCE, No. 677/II-55, pp. 75-86, 2001.
  18. [18] L. X. Luu, S. Egashira, and H. Takebayashi, “Investigation of Tan Chau reach in lower Mekong using field data and numerical simulation,” Annual J. of Hydraulic Engineering, JSCE, Vol.48, 2004.
  19. [19] H. Takebayashi, “Instability of stream geometry,” Proc. of the Fourth Int. Conf. on Scour and Erion, pp. 134-139. 2008.
  20. [20] S. Egashira, M. Kuroki, K. Sawai, and M. Yamasaka, “Methods to evaluate the bed shear stress in open channel flow,” Proc. of the 32nd Japanese Conf. on Hydraulics, pp. 503-521, 1988.
  21. [21] K. Hasegawa and A. Mochizuki, “Formation process of an equilibrium cross section in a straight channel of sand-silt river,” 4th Int. Seminar on River Sedimentation, Beijing, China, pp. 417-424, 1989.
  22. [22] M. Kuroki and T. Kishi, “Regime criteria on bars and braids in alluvial straight channel,” Proc. JSCE, Vol.42, pp. 87-96, 1984 (in Japanese).
  23. [23] F. Engelund, “Flow and bed topography in channel bends,” J. of Hydraulic Division, ASCE, Vol.100, No.HY11, pp. 1631-1648, 1974.
  24. [24] A. Yorozuya, M. S. Islam, M. Kamoto, and S. Egashira, “Influence of Jamuna Bridge on River Morphology,” Advances in River Sediment Research, Fukuoka etal.(eds), Taylor & Francis Group, London, pp. 299-308, 2015.
  25. [25] S. Egashira, K. Ashida, J. Takahama, and S. Tanonaka, S. “Derivation of bed-load formula from a view point of continuum body,” Proc. of Hydraulic Engineering, JSCE, Vol.35, pp. 441-446, 1991 (in Japanese).
  26. [26] R. K. Biswas, A. Yorozuya, and S. Egashira, “ Modified Grdient Based Method for Mapping Sandbars in Mega-sized Braided River using MODIS Image,” Annual J. of Hydraulic Engineering, JSCE, Vol.60, pp. 931-936, 2016.
  27. [27] J. G. Klaassen and G. Masselink, “Planform changes of a braided river with fine sediment as bed and bank materials,” 5th Int. Symposium on River Sedimentation, Karlsruhe, Germany, 1992.
  28. [28] S. Okada, A. Yorozuya, H. Koseki, S. Kudo, and K. Muraoka, “Comprehensive measurement techniques of water flow, bedload and suspended sediment in large river using Acoustic Doppler Current Profiler,” Proc. of the Int. Symposium on River Sedimentation, September 2016.

Creative Commons License  This article is published under a Creative Commons Attribution-NoDerivatives 4.0 Internationa License.

*This site is desgined based on HTML5 and CSS3 for modern browsers, e.g. Chrome, Firefox, Safari, Edge, Opera.

Last updated on Apr. 05, 2024