Top > Most Downloaded > IJAT Most Downloaded Papers, October 2016

single-mostdl.php

IJAT Most Downloaded Papers, October 2016

This month Last month Vol. No. Title / Authors Keywords
No.1 - Vol.8
No.1
(2014)		 Error Calibration for Five-Axis Machine Tools by On-the-Machine Measurement Using a Touch-Trigger Probe
Soichi Ibaraki and Yusuke Ota 		five-axis machine tools, touch-trigger probe, geometric errors, error map, error calibration
No.1 - Vol.8
No.5
(2014)		 Fuel Operated Heaters Applied to Electric Vehicles
Tetsushi Mimuro and Hiroyuki Takanashi 		electric vehicle, air conditioning, PTC heater, heat pump heater, fuel operated heater
No.2 - Vol.2
No.5
(2008)		 Micropitting Generation Mechanism for Gears
Nobuyoshi Yoshida and Tokihiko Taki 		micropitting, generation mechanism, gear, stress analysis
No.2 - Vol.3
No.6
(2009)		 Muscle Suit Development and Factory Application
Hiroshi Kobayashi, Takamitsu Aida, and Takuya Hashimoto 		wearable robot, power assist, McKibben artificial muscle, work-related disorder, muscle suit
No.2 - Vol.7
No.4
(2013)		 The Use of Machine Tool Internal Encoders as Sensors in a Process Monitoring System
Tomas Beno, Jari Repo, and Lars Pejryd 		milling, tool wear detection, encoder signals, monitoring system architecture
No.2 - Vol.9
No.1
(2015)		 Development and Control of a Low-Cost, Three-Thruster, Remotely Operated Underwater Vehicle
Khoa Duy Le, Hung Duc Nguyen, and Dev Ranmuthugala 		remotely operated vehicle (ROV), hybrid controller, model-based control, PID control, open source hardware
No.2 - Vol.9
No.4
(2015)		 R-Test Analysis Software for Error Calibration of Five-Axis Machine Tools – Application to a Five-Axis Machine Tool with Two Rotary Axes on the Tool Side –
Soichi Ibaraki, Yu Nagai, Hisashi Otsubo, Yasutaka Sakai, Shigeki Morimoto, and Yosuke Miyazaki 		Metrology, R-test, five-axis machine tools, calibration, location error, error motion, geometric error.
No.2 - Vol.9
No.6
(2015)		 Kinematics Analysis of a Novel 5-DOF Hybrid Manipulator
Wanjin Guo, Ruifeng Li, Chuqing Cao, and Yunfeng Gao 		hybrid manipulator, kinematics, inverse kinematics, reachable workspace
No.2 - Vol.10
No.2
(2016)		 Fractals and Additive Manufacturing
A. M. M. Sharif Ullah, D. M. D’Addona, Khalifa H. Harib, and Than Lin 		fractal geometry, additive manufacturing, point-cloud, convex-concave-hull, non-contact measurement
No.2 - Vol.10
No.4
(2016)		 Development of a Hose-Free FMA Driven by a Built-In Gas/Liquid Chemical Reactor
Akira Wada, Hidehiro Kametani, Koichi Suzumori, and Shuichi Wakimoto 		actuator, pneumatic actuator, hose-free pneumatic actuator

Count period : October 1-31, 2016

*This site is desgined based on HTML5 and CSS3 for modern browsers, e.g. Chrome, Firefox, Safari, Edge, Opera.

Last updated on Apr. 22, 2024