single-rb.php

JRM Vol.10 No.6 pp. 528-532
doi: 10.20965/jrm.1998.p0528
(1998)

Paper:

Optopneumatic Interface for Controlling Pneumatic Power Circuits

Guido Belforte and Gabriella Eula

Department of Mechanics, Politecnico di Torino, C.so Duca degli Abruzzi, 24 - 10129 Torino - Italy

Received:
July 13, 1998
Accepted:
November 9, 1998
Published:
December 20, 1998
Keywords:
Optopneumatic Interface, Pneumatic interface, Photoacoustic device, Optopneumatic system
Abstract

This paper presents a study of an optopneumatic interface integrated with a pressure amplifier stage. The interface works using photothermicity to generate a weak pressure signal in its control chambers. In photothermicity, infrared light strikes a black body a few microns thick, increasing the temperature of the black body and air close to it. If this air is in the control chamber of the optopneumatic interface, its expansion generates a pressure control signal, amplified to make it suitable for common low/high commercial pressure valves. This control enables the command of pneumatic actuators in hazardous environments, with the electrical signal transformed into optical and transported using optical fiber; all electrical parts can be located at a distance from direct application. Our results showed that the device’s response times, accuracy, and repeatability are suited to many applications. Below is an example of a command integrating electric, optical, and pneumatic techniques and operating by an infrared source with very low light power.

Cite this article as:
Guido Belforte and Gabriella Eula, “Optopneumatic Interface for Controlling Pneumatic Power Circuits,” J. Robot. Mechatron., Vol.10, No.6, pp. 528-532, 1998.
Data files:

*This site is desgined based on HTML5 and CSS3 for modern browsers, e.g. Chrome, Firefox, Safari, Edge, Opera.

Last updated on Sep. 19, 2021