single-au.php

IJAT Vol.3 No.4 pp. 457-464
doi: 10.20965/ijat.2009.p0457
(2009)

Paper:

In-Process Measurement of Elastic Deformation of a Large Deep-Drawing-Die with Fusion of Experiment and Numerical Analysis

Takahiro Ohashi*, Tomoaki Ando**, and Noriyuki Nakaoka**

*Kokushikan University, 3-4-1 Setagaya, Setagaya-ku, Tokyo 154-8515, Japan

**Advanced Simulation Technology of Mechanics (ASTOM) R&D, Co. Ltd., 2-3-13 Minami, Wako-shi, Saitama 351-0104, Japan

Received:
September 9, 2008
Accepted:
March 24, 2009
Published:
July 5, 2009
Keywords:
die, press-working, deep drawing, in-process measurement, numerical analysis
Abstract
We measured elastic deformation of a large deep drawing die in-process and visualized it with a fusion technique of numerical analysis and experiments with multipoint die support. We found that displacement by elastically deforming a press machine bolster is up to 0.15 mm when measured directly by displacement sensors. Lower die profile displacement for a half size fender is estimated at 0.25 mm. We numerically analyzed elastic die deformation using multipoint die support to measure and visualize deformation indirectly. We calculated reactive force distribution on the cavity surface and to know it differs with according to distribution pattern of support points, and visualized elastic deformation die patterns.
Cite this article as:
T. Ohashi, T. Ando, and N. Nakaoka, “In-Process Measurement of Elastic Deformation of a Large Deep-Drawing-Die with Fusion of Experiment and Numerical Analysis,” Int. J. Automation Technol., Vol.3 No.4, pp. 457-464, 2009.
Data files:
References
  1. [1] I. Ohnaka, H. Yasuda, A. Sugiyama, and T. Ohmichi, Trans. Indian Institute of Metals, 58, 603-610, 2005.
  2. [2] Y. Murata, T. Yokoi, H. Kawasaki, Journal of the Japan Society of Polymer Processing, 8-4, 249, 1996.
  3. [3] Y. Murata, T. Higeta, T. Orita, Proc. Polymer Processing Symposia 2005, 185.
  4. [4] M. Horihata and M. Motomura, Journal of the Japan Society of Technology of Plasticity, 30-344, 1302-1307, 1989.
  5. [5] Y. Tozawa, T. Ishikawa, Mem. Fac. Eng. Nagoya Univ., 36-2, 79-117, 1984.
  6. [6] J. Kihara, H. Makino, M. Shin, Journal of the Japan Society of Technology of Plasticity, 25-284, 806, 1984.
  7. [7] H. Tsutamori and F. Yoshida , Journal of the Japan Society of Technology of Plasticity, 46-532, 407-411, 2004.

*This site is desgined based on HTML5 and CSS3 for modern browsers, e.g. Chrome, Firefox, Safari, Edge, Opera.

Last updated on Oct. 01, 2024