single-au.php

IJAT Vol.2 No.5 pp. 377-383
doi: 10.20965/ijat.2008.p0377
(2008)

Paper:

Efficiency Comparison of Cutting Strategies for End Milling Processes Under Feedrate Scheduling

Soichi Ibaraki*, Atsushi Matsubara*, and Masanori Murozumi**

*Department of Micro Engineering, Kyoto University
Yoshida-Honmachi, Sakyo-ku, Kyoto 606-8501, Japan

**Mori Seiki Co., Ltd.
2-35-16 Meieki, Nakamura-ku, Nagoya, Aichi 450-0002, Japan

Received:
March 14, 2008
Accepted:
July 21, 2008
Published:
September 5, 2008
Keywords:
End milling, process planning, feedrate scheduling, machining efficiency, high-speed cutting
Abstract

Technical advances in high-speed machining centers and cutting tools have made high-speed cutting a major player in manufacturing applications, but high-speed cutting provides higher machining efficiency only when machining conditions are appropriately set. In contrast, expert job shop operators often choose a heavy cutting strategy subject to higher depth of cut and a lower feedrate. Feedrate scheduling schemes are widely recognized as practically feasible for optimizing machining conditions in high-speed cutting. We compared the productivity of high-speed milling and heavy milling, assuming that using feedrate scheduling optimizes machining conditions. Possible cutting strategies are interpreted as constraints on cutting conditions or cutting performance, then machining conditions are scheduled optimally to maximize the productivity. A case study illustrates these points.

Cite this article as:
Soichi Ibaraki, Atsushi Matsubara, and Masanori Murozumi, “Efficiency Comparison of Cutting Strategies for End Milling Processes Under Feedrate Scheduling,” Int. J. Automation Technol., Vol.2, No.5, pp. 377-383, 2008.
Data files:

*This site is desgined based on HTML5 and CSS3 for modern browsers, e.g. Chrome, Firefox, Safari, Edge, Opera.

Last updated on Mar. 05, 2021