Paper:
Views over last 60 days: 352
Development of Jumping & Rolling Inspector to Improve the Debris-traverse Ability
Hideyuki Tsukagoshi, Yotaro Mori, Masashi Sasaki, Takahiro Tanaka, and Ato Kitagawa
Tokyo Institute of Technology, 2-12-1 Ohokayama, Meguro-ku, Tokyo, 152-8552 Japan
Received:April 21, 2003Accepted:May 19, 2003Published:October 20, 2003
Keywords:rescue robot, jumping robot, pneumatic power, design of the reduced degrees
Abstract
The design and motion experiments of the newly constructed jumping & rolling inspector Leg-in-rotor-II are discussed. The features of Leg-in-rotor-II are as follows: (i) The driving method of 3-D jumping & rolling by the reduced degrees of freedom on the separated drive. (ii) The introduction of the passively stored leg. (iii) The introduction of the wheel with the light anisotropy elasticity of the high changing ratio. (iv) The pneumatic jumping control method and its energy saving. (v) The sensing method to estimate the desired jumping start point. (vi) The structure of the sideway tumble prevention and the shock buffer. Finally, the motion experiments of Leg-in-rotor-II to roll, jump and land on debris are shown and the validity of the introduced design methods is verified.
Cite this article as:H. Tsukagoshi, Y. Mori, M. Sasaki, T. Tanaka, and A. Kitagawa, “Development of Jumping & Rolling Inspector to Improve the Debris-traverse Ability,” J. Robot. Mechatron., Vol.15 No.5, pp. 482-490, 2003.Data files:
Copyright© 2003 by Fuji Technology Press Ltd. and Japan Society of Mechanical Engineers. All right reserved.
