Paper:
Views over last 60 days: 379
Polishing Robot Using Joystick Controlled Teaching
Fusaomi Nagata*, Keigo Watanabe**, Satoshi Hashino***, Hiroyuki Tanaka*, Takuro Matsuyama* and Kenji Hara****
*Interior Design Research Institute, Fukuoka Industrial Technology Center, Agemaki-405-3, Ohkawa, Fukuoka 831-0031, Japan
**Department of Advanced Systems Control Engineering, Graduate School of Science and Engineering, Saga University, Honjomachi-1, Saga 840-8502, Japan
***Fukuoka Industrial Technology Center, Kamikoga 3-2-1, Chikushino, Fukuoka 818-8540, Japan
****Mechanics & Electronics Research Institute, Fukuoka Industrial Technology Center, Yahatanishiku Norimatsu 3-6-1, Kitakyushu, Fukuoka 807-0831, Japan
Received:April 5, 2001Accepted:May 18, 2001Published:October 20, 2001
Keywords:force control, impedance control, profiling control, cutter location data, teaching, joystick, industrial robot, polishing
Abstract
In this article, an impedance model following force control, which uses a position/orientation compensator based on joystick-taught data, is proposed for an industrial robot with an open architecture controller. The present method has two characteristics: it is easily applied to the task where an industrial robot polishes an object with desired contact force and orientation and does not need conventional complicated teaching. The effectiveness and promise of the proposed method are demonstrated through experiments in a polishing task using an industrial robot FS-30.
Cite this article as:F. Nagata, K. Watanabe, S. Hashino, H. Tanaka, T. Matsuyama, and K. Hara, “Polishing Robot Using Joystick Controlled Teaching,” J. Robot. Mechatron., Vol.13 No.5, pp. 517-525, 2001.Data files:
Copyright© 2001 by Fuji Technology Press Ltd. and Japan Society of Mechanical Engineers. All right reserved.