Paper:
Torque Reduction Method for Redundant Manipulator
Kenji Uematsu* and Toshio Fukuda**
*Department of Micro System Engineering, Graduate School of Engineering
**Center for Cooperative Research in Advanced Science & Technology, Nagoya University, 1 Furo-cho, Chikusa-ku, Nagoya 464-8601, Japan
Redundant manipulators are used to avoid collisions and conduct motion in which all manipulator links avoid the obstacle in work space. The manipulator changes position by adjusting a redundant degree of freedom, simultaneously, but joint torque saturates and error at the end point increases with the number of components. We propose bracing control to contact the intermediate point of the redundant manipulator with the environment and to use contact force as equivalent control input to compensate for joint torque. We verify the effectiveness of our proposal through simulation.
This article is published under a Creative Commons Attribution-NoDerivatives 4.0 Internationa License.
Copyright© 1999 by Fuji Technology Press Ltd. and Japan Society of Mechanical Engineers. All right reserved.