Paper:
Views over last 60 days: 394
On-line Identification of Furnace Parameters for Coal-Fired Boiler Control
Yukio Fukayama*, Kotaro Hirasawa**, Katsumi Shimohira*, Toshikazu Tsumura***, and Koji Yamamoto***
*Babcock-Hitachi Kure Research Laboratory
**Department of Electrical and Electronic Systems Engineering, Kyushu University
***Kure Works, 3-36 Takara-machi, Kure, Hiroshima 737-8508, Japan
Received:April 19, 1999Accepted:June 5, 1999Published:October 20, 1999
Keywords:identification, Kalman filter, dynamics model, numerical stability, boiler
Abstract
A new identifier for furnace parameters on control coalfired boilers fuel ratio dominating coal burning speed and slagging factor influencing the heat resistance on heating surfaces was applied to a 1000MWe power station. The identifier is based on the Extended Kalman Filtering on a nonlinear boiler dynamics model including energy and mass conservation laws in continuous time with seeking parameters fluctuated as the Brownian motion. The identifier refers to not only measured gas and water temperature at boilers (observable) but also actual fuel flow of each burner (manipulation) for the guidance to plant operators to cope with parameter fluctuation. Due to numerical stability, the identifier uses both Pade (1,1) approximation for time discretizing and U-D factorization for calculating the covariance matrix.
Cite this article as:Y. Fukayama, K. Hirasawa, K. Shimohira, T. Tsumura, and K. Yamamoto, “On-line Identification of Furnace Parameters for Coal-Fired Boiler Control,” J. Robot. Mechatron., Vol.11 No.5, pp. 374-379, 1999.Data files:
Copyright© 1999 by Fuji Technology Press Ltd. and Japan Society of Mechanical Engineers. All right reserved.
