Paper:
Views over last 60 days: 320
Trajectory Planning of Knife Position of Slitter Robot Based on Identification of Friction and Viscous Damping, and Position Control Experiments
Hiroyuki Kojima*, Daiki Orihara*, Yamato Matsuda**, Yusuke Inoue*, and Hiroyuki Negishi***
*Department of Mechanical System Engineering, Graduate School of Engineering, Gunma University
1-5-1 Tenjincho, Kiryu, Gunma 376-8515, Japan
**Mazda Motor Corporation
3-1 Shinchi, Futyucho, Akigun, Hiroshima 730-8670, Japan
***Fujiyuatsu Seiki Corporation
1250-2 Izumisawamachi, Maebashi, Gunma 379-2101, Japan
Received:June 10, 2008Accepted:July 21, 2008Published:September 5, 2008
Keywords:slitter robot, trajectory planning, position control, identification, frictional force
Abstract
In this study, the trajectory planning method of the knife position of a slitter robot is proposed, and the experimental and numerical simulation results are demonstrated. The slitter robot consists of upper and lower knife driving mechanisms, and a knife driving mechanism was constructed with a worm gear, a ball screw and an alternating current (AC) motor. In the trajectory planning, first, the identification algorithm of the friction and the viscous damping is derived by using the equation of motion of the knife drive mechanism and the experimental results of the dynamic response with constant AC motor torque. Then, the trajectory planning algorithm of the knife position is presented, and a knife position control system is constructed. Furthermore, the experiments and numerical calculations have been carried out, and the usefulness of the present trajectory planning method is confirmed.
Cite this article as:H. Kojima, D. Orihara, Y. Matsuda, Y. Inoue, and H. Negishi, “Trajectory Planning of Knife Position of Slitter Robot Based on Identification of Friction and Viscous Damping, and Position Control Experiments,” Int. J. Automation Technol., Vol.2 No.5, pp. 354-359, 2008.Data files:
